The cabinet should be located within 1m of the Kitchen Extract ductwork, on the negative pressure side, as near to the kitchen canopy as possible, thus ensuring the maximum length of time the odour neutraliser is in contact with the odours.
Check all joints on ductwork to ensure proper connection and all joints should be properly taped. Be careful when cutting through ceilings or walls not to damage any hidden pipes or electrical wiring. Ensure your kitchen has from the front edge of the cabinet (refer to figure 3).
Or cost prohibitive to run all welded ductwork to the roof. The cleaned kitchen exhaust air from the ACW) and the Air Monitor Cabinet on the fil-ter section is low voltage 24 VAC. The panel can be optionally equipped with Low Odor
Use in kitchen. Grounded electrical system is required. See metal ductwork. This downdraft cooktop is Not approved for use in mobile homes. cabinet is protected by not less than l/4” flame
A Job Safety Analysis (JSA) is one of the risk assessment tools used to identify and control workplace hazards. A JSA is a second tier risk assessment with the aim of preventing personal injury to a person, or their colleagues, and any other person passing or working adjacent, above or below
* Based on “Kitchen Fire Safety Tips” published by NFPA. for proper placement of ductwork and electrical cutout in cabinet or wall. For a non-ducted installa-tion, DO NOT cut a duct access hole. 3 Run house wiring between service panel and hood location.
Back into kitchen out of the cabinet Controls 3 Speed Electronic Push w/ Blue LED Lighting 2 X 20 (W) Halogen Ducting Top 6” Round kitchen. Some ductwork is required to exhaust the unit out of the cabinet. Charcoal Filters # FILTER1 Create a
Ductwork can extend either kitchen odors. • Never use the hood for purposes other than for which it has ben designed. disconnect and move freestanding or slide-in range from cabinet opening to pro-vide easier access to rear wall.
kitchen and exterior wall anywhere within the duct line), or a remote (mounted on the roof or outside wall). cabinet work, ductwork or electrical/gas utilities for the cooktop. All power for the vent system (including the remote blower, if used) is
DUCTWORK. 11 012 Page 2 Ducting Do’s and Don’ts NEVER restrict the duct size. The K250 blower unit requires 7” round duct or equivalent (32.5 square inches). If the underside of the cabinet is recessed, install
Kitchen Ventilation Systems and Food Service Equipment Fabrication and Installation Guidelines 6.3.2 DUCTWORK 6.2 Figure 6–1 Free Standing Cabinet — Open 6.1
From the kitchen. Some ductwork is required to exhaust the unit out of the cabinet. YOU MUST ORDER TWO OF PART #6093034 (ONE KIT FOR EACH OF THE TWO INCA PRO 38 MOTORS) Inca Pro 38 (1100 cfm internal) a fusion of power and style Built – In Collection
A Based on “Kitchen Firesafety Tips” published by NFPA. CAUTION 1. For indoor use only. 2. For general ventilatinguse only. CABINET FOR DUCTWORK, check for interference with floor joists, wall studs, electrical wir-ing, or plumbing. 1.
† Ductwork can be installed vertically or horizontally † Duct runs should be as short as possible † Avoid the use of elbows † Use metal foil duct tape at all joints KITCHEN CABINET CUTOUT DIMENSIONS 51